The Whizzard Urine Fetish Kit

The Whizzard is a standard base model and is a complete discrete synthetic urine novelty kit with the most life-like realistic fake penis. The medical-grade synthetic urine device features an ultra-quiet flow system that is very easy to use and operates with ONE hand.

THE BASICS

This hyper-realistic appendage is quiet and delivers a steady flow with a subtle squeeze. You may need to be wearing the Whizzinator for at least an hour before you plan to use it, so be prepared! For the most realistic experience, practice first by doing a test run using only warm water so you feel confident. Make sure you have everything you need:

THE WHIZZINATOR KIT:

• Belt kit with a synthetic penis, attached to the bladder with temperature strip
• Two hand-warmers
• Powdered synthetic urine

ACCESSORIES YOU WILL NEED FROM HOME:

• Two tall glasses
• Warm water
• Teaspoon to mix the powdered urine

DIRECTIONS:

Preparing the Synthetic Urine:

• Fill a glass with warm water (it should feel warmer than skin temperature, neither hot nor cold).
• Take the syringe and fill it to 60mL (with the tip of the syringe submerged in the water, slowly pull the white handle upwards and it will start filling). Once filled to 60mL, expel the water from the syringe into the second glass.
• Fill the syringe again to 30mL and expel that water into the second glass. Now you'll have 90mL of warm water.
• Take the powdered urine from the small vial and empty it into the second glass of warm water. Stir with a teaspoon until all the particles have dissolved. It will bubble slightly and smell very realistically.
• Refill the syringe with the synthetic urine you have prepared and get the belt kit ready.

Filling the Belt Kit:

• Unscrew the refill port (white nozzle lid attached to the bladder bag).
• Position the syringe tip into the refill port and slowly start pressing down on the syringe to fill the "bladder". Don't hurry this step, or it will get messy! When the bladder is full (there will be a small amount of leftover liquid in the glass), withdraw the syringe and twist the nozzle lid on the bag closed.
• With the nozzle closed and the bladder full of synthetic urine, have a look at the temperature strip on the bladder. This needs to read green on 98. Depending on the warmth of the water you've used, it might be slightly above or below this.

Applying The Heat Pad:

• Open the heating pack and remove the bag inside.
• Shake the bag to activate it.
• Peel off the adhesive backing and apply the sticky backing side to the back of the bladder (in between the bladder and the belt). This will help the bladder stay at a constant temperature of approximately 98 degrees.

 Putting on the Belt:

• The belt needs to be put on "upside down", so the readings on the temperature strip are facing you while you are wearing it. The white nozzle should be facing up toward you. The penis will then flop down over the front of the bladder.
• There is a Velcro tab on the right-hand side of the belt so you can adjust it to fit snugly.

Using the Whizzinator:

• Remove the plug from the tip of the penis. Squeeze just below the head of the penis with the thumb on top and the index finger below, and the synthetic urine will flow while you squeeze. It will stop flowing when you stop squeezing. For a realistic continuous stream, push back on the bladder with your hand as you squeeze.
• For future use, you can purchase pre-mixed synthetic urine and reheat it in the microwave for 5-10 seconds.
• Keep it clean between uses by running a 10/90 mixture of hydrogen peroxide and water through the bladder.

Features:

• 1 Golden Shower Dehydrated Synthetic Urine
• Colour - White
• 100% Cotton Elastic Belt
• Refillable Vinyl Pouch
• Quiet Release Valve
• Easy Read Temperature Strip
• 60 ml Syringe • 2 Heat Pads
• Set of Tips and Instructions

What’s in the Box:

• The Whizzard
• Refillable vinyl pouch
• 1 Golden Shower Synthetic Urine Sample
• 2 Heat Pads
• 1 Syringe
• 1 instruction manual